Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 12, 2010 at 2:56 pm #5167
    dtobonme
    Participant

    Hello,

    I want know in which units we must give the RUL. Cuts, meters, other? If the units are a length can you tell us how many passes you did for each cut.

    Thank you

    Hello,

    I want know in which units we must give the RUL. Cuts, meters, other? If the units are a length can you tell us how many passes you did for each cut.

    Thank you

    July 23, 2010 at 9:20 am #5601
    eklund
    Keymaster

    You will want to predict the maximum expected wear after each cut for ANY of the three flutes in units of 10^-3 mm. There will be a small penalty for over-prediction (i.e., being too conservative), and a larger penalty for under-prediction (i.e., being too liberal).

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.